There are four modes to diagnose the electrical systems, which can be accessed by depressing the Model Button and cycling through each one. DC Voltage AC Voltage Resistance Diode. Circuit Continuity Testing in Resistance mode. While the tool is in Resistance mode, using the probe tip with chases is ground or the auxiliary ground lead, continuity can be tested on wires and components attached or disconnected from the vehicle's electrical system, When the probe tip is contacting a ground, the LCD will indicate "0.0O" and green LED will be on, A beep tone will sound.
Activating Components in Your Hand. Activating Components in The Vehicle. Testing Trailer Lights and Connections. For example, you suspect there is a problem with your M.Sensor circuit, then follow the procedure involved with testing this sensor. Set the tool in AC Voltage mode, using the probe tip with chassis ground or the auxiliary ground lead. Connect vacuum pump to MAP sensor Connect the probe tip to the MAP sensor, Positive terminal and observe the LCD readings which should be a sine wave in normal condition, Apply vacuum Release vacuum and observe the LCD readings. The KM10 power scan kit is the most revolutionary circuit tester to date, featuring AVOmeter, test light, built -in flashlight, short circuit indicator, relay/component tester, continuity tester and bad groud indicator, the power scan is truly the ultimate in power and affordablity, allowing users to check circuitry in one single step. An absolute must for every technician looking for a fast and accurate solution to electrical systems diagnostics. Performs every type of service including power injection, measurement, ground testing, polarity checks, continuity testing and components activation. With a flip of the power switch, you have an instant hot/ground lead for powering up electrical components like cooling fans, relays, etc. Simultaneously uses the hot lead and the ground lead to activate components right in your hand. Instantly identifies positive, negative and open circuits. Tests for bad ground contacts instantly, allowing you to follow and locate shorts fast without wasting fuses. Instantly checks continuity of switches, relays and diodes. Audio tone indicator allows for no-look menu scrolling once users are familiar with menu tone assignment.
9.20ft (extendable) cable provides excellent accessibility to test along the vehicle. DC voltage range: 0-65V +1digit. Frequency response of tone pass through 0Hz to 10Khz. Testing Standard:100% current: Hold > 1 hour150% current: trip in one hour200% current: trip in 3-30 seconds. 300% current: trip in 0.5-4.0 seconds.Activating Components in Your Hand and The Vehicle. With a flip of the power switch, you have a hot instant/grounding for voltage & polarity testing.
It powers up components such as windows, lights, starters, wipers, and so on. Simultaneously uses the hot lead and the ground wire to activate elements right in your hand. Display: TFT color display (160 x 128 dpi). Operating Temperature: 0 to 60 (32 to 140). External Power: 12.0 or 24.0 V power provided via vehicle battery.
1 × Rugged Blow Molded Case. 1 × Battery Hookup Clips. 1 × Cigarette Lighter Adapter.
This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts & Accessories\Exterior Parts & Accessories\Body Moldings & Trims". The seller is "dukenukemmaxxx" and is located in this country: CN. This item can be shipped worldwide.